Struct rust_ipv8::payloads::puncturepayload::PuncturePayload

pub struct PuncturePayload {
    pub lan_walker_address: Address,
    pub wan_walker_address: Address,
    pub identifier: u16,
}

Payload used for NAT puncturing, containg the addresses which should be used communicate.

Fields

lan_walker_address: Address

is the lan address of the sender. Nodes in the same LAN should use this address to communicate.

wan_walker_address: Address

is the wan address of the sender. Nodes not in the same LAN should use this address to communicate.

identifier: u16

is a number that was given in the associated introduction-request. This number allows to distinguish between multiple introduction-response messages.

Trait Implementations

impl Ipv8Payload for PuncturePayload

impl PartialEq<PuncturePayload> for PuncturePayload

fn eq(&self, other: &PuncturePayload) -> bool

This method tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &PuncturePayload) -> bool

This method tests for !=.

impl Debug for PuncturePayload

fn fmt(&self, f: &mut Formatter) -> Result

Formats the value using the given formatter.

impl Serialize for PuncturePayload

fn serialize<__S>(&self, __serializer: __S) -> Result<__S::Ok, __S::Error> where
    __S: Serializer, 

Serialize this value into the given Serde serializer.

impl<'de> Deserialize<'de> for PuncturePayload

fn deserialize<__D>(__deserializer: __D) -> Result<Self, __D::Error> where
    __D: Deserializer<'de>, 

Deserialize this value from the given Serde deserializer.